오실레이터 MomentumTrendZero Line Builder에서 사용 가능
TRIX
TRIX is the rate of change of an exponential average that has been applied three times. The triple smoothing removes most short-term movement before momentum is measured, so the line crosses zero rarely — which is the whole point of using it instead of a faster oscillator.
- Default period
- 14
- Signal level
- Zero
- Smoothing
- EMA × 3
예시용 — 합성 데이터로, 실시간 호가가 아닙니다.
What TRIX tells you
TRIX answers whether a heavily smoothed version of price is still speeding up. An EMA is applied to price, then to that result, then again — by the third pass almost every short swing has been averaged away. TRIX then measures how fast what remains is changing. Above zero the smoothed trend is rising; below zero it is falling. Because the input is so smooth, the sign changes only a handful of times in a long stretch of chart.
- Above zero: the triple-smoothed average is climbing
- Crossing zero: the smoothed trend has turned
- The value's magnitude is instrument-dependent — only the sign and the shape transfer
- 1 Apply an EMA to the closing price
- 2 Apply the same EMA twice more to its own output
- 3 Measure the bar-to-bar rate of change of the result
공식 및 계산 세부 정보 표시
TRIX is built by smoothing, three times over, and then asking how fast the result is moving:
E1 = EMA(close, n)E2 = EMA(E1, n)E3 = EMA(E2, n)TRIX = (E3 − E3[1]) / E3[1]
The first three steps are the indicator’s whole idea. A single EMA still follows most of the swings in price; a second pass removes a good deal of what is left; by the third almost nothing but sustained direction survives. Only then is momentum measured, which is why TRIX responds to trend changes and largely ignores the movement around them.
In MQL5 the call is iTriX(symbol, period, applied_price). There is one buffer and no signal line — if a strategy refers to “TRIX crossing its signal”, it was written for a platform whose version draws a second, separately smoothed line that MetaTrader’s does not include.
Two things follow from the construction. First, the lag compounds: TRIX(14) is far slower than an EMA(14), because the period is applied three times in series. That is a deliberate trade and the reason the indicator normally lives on H4 and daily charts. Second, the scale is not portable — TRIX is a rate of change on a smoothed price, so its magnitude carries the instrument’s units and the timeframe’s. Zero is the only level that means the same thing on every chart, and it is the only one the Builder’s template uses.
The practical consequence is that TRIX signals are rare. Over a year of hourly data a zero cross might fire a couple of dozen times where a MACD crossover fires hundreds. If that seems too quiet, the honest response is a shorter period or a different indicator — not extra conditions bolted on to manufacture entries in between. The reason to reach for TRIX in the first place is that it stays silent through the chop where a faster oscillator does most of its losing.
신호
TRIX이 제공하는 백테스트 가능한 뚜렷한 신호 — 및 각 신호에 적합한 시장 상황.
Slope While Above Zero
Builder로 구현 가능Failed Cross
Builder로 구현 가능Divergence from Price
고급 로직MT5 구현
MetaTrader 5가 실제로 계산하고 그리는 내용 — 이 페이지의 모든 규칙이 기준으로 삼는 사양입니다.
버퍼
| 인덱스 | 버퍼 | MT5 표시 방식 | 저장 값 |
|---|---|---|---|
| 0 | MAIN_LINE | Line | The rate of change of the triple-smoothed EMA. One buffer, drawn as a line around zero. MT5's TRIX has no signal line — a second line over a TRIX chart is a separate indicator someone added. |
플랫폼 참고
가장 잘 작동하는 경우 / 주의해서 사용
어떤 지표도 보편적인 우위를 가지지 않습니다. TRIX이 도움이 되는 곳 — 그리고 오해를 일으키는 곳.
가장 잘 작동하는 경우
- Higher timeframes, where its slowness costs less
- Trending instruments held for days rather than hours
- As the entry trigger with a longer average deciding direction
- Situations where fewer, later signals are preferable to more, earlier ones
주의해서 사용
- Ranging markets — a late signal in a range is the worst of both
- Short timeframes, where the lag can exceed the move
- Any fixed threshold on the value
- Expecting it to call tops and bottoms; it confirms, it does not predict
TRIX 전략 구축
신호를 진입 및 청산 규칙에 연결하고, 컴파일 가능한 MT5 EA를 내보내세요 — 코드 없이.
- TRIX read at the current bar
- A Constant of 0 to cross against
- TRIX crosses above zero → the long trigger
- EMA(200) and current price into a Compare — price above it allows longs
- Both true → Open Buy · SL 60 / TP 180
- Stop then trails to the most recent confirmed fractal
TRIX을 다른 지표와 결합
하나의 지표만으로는 충분하지 않습니다. 이 조합들이 TRIX의 취약점을 보완합니다.
TRIX + Moving Average
- Price above the EMA(200)
- TRIX crosses above zero
- Buy
TRIX + ADX
- ADX above 25
- TRIX crosses above zero
- Buy
No single-flow template pairs TRIX with ADX. Start from TRIX Zero Cross + EMA200 and add an ADX node with a Compare at 25, the same filter the Parabolic SAR template uses.
Builder 열기 →TRIX + MACD
- MACD's MAIN above SIGNAL
- TRIX above zero
- Buy
No single-flow template pairs TRIX with MACD. Start from TRIX Zero Cross + EMA200 and add two MACD nodes (Main and Signal) with a Compare between them.
Builder 열기 →매개변수
자신의 통화쌍과 시간 프레임에서 검증할 초기값 — 보장된 설정이 아닙니다.
| 매개변수 | 기본값 | 권장 테스트 범위 | 기능 |
|---|---|---|---|
| Period | 14 | 9–30 | The length used for all three averages. Because the smoothing compounds, raising this has a much stronger effect than on a single EMA — a period of 20 here is far slower than a 20-period EMA. Shorter periods restore some responsiveness at the cost of the noise rejection that is the reason to use TRIX at all. |
| Applied price | PRICE_CLOSE | Close, Open, High, Low, Median, Typical, Weighted | Which series feeds the first average. It really is an argument to iTriX and the Builder passes it through as an EA input. Median or Typical make the input slightly less jumpy before the smoothing even starts. |
| Shift | 0 | 0–30 | Which bar back the node reads the buffer from. Two TRIX nodes at different shifts is how a rule expresses 'still rising', since the indicator publishes no signal line to compare against. |
초기 프리셋
Faster 9 More zero crosses; some of the noise comes back
Standard 14 MT5's default, and the template's
Regime 25 Very few crosses, each describing a large move
시장 예시
TRIX이 작동하는 곳, 실패하는 곳, 그리고 필터가 결과를 어떻게 바꾸는지.
A turn that survives the smoothing
TRIX crosses zero while price is already above the EMA(200). The move that follows lasts long enough for the fractal trail to ratchet the stop up several times.
A cross against the larger trend
TRIX turns up but price is below the EMA(200). Taken on its own the signal is a counter-trend entry into a falling market — the filter is what stops it.
The quiet stretch produces nothing
Weeks of range-bound chop pass without a single zero cross. A faster oscillator would have signalled repeatedly here; TRIX's silence is the intended behaviour.
FAQ
- What does the 'triple' in TRIX mean?
- An exponential moving average is applied to the closing price, then the same EMA is applied to that result, and then once more to that. TRIX is the rate of change of the third output. Each pass removes more short-term movement, so by the third the line responds only to sustained changes in direction.
- Is TRIX just a slower MACD?
- They are related but not the same. MACD is the difference between two averages of different lengths; TRIX is the rate of change of one average smoothed three times. MACD reacts to the gap between fast and slow opening up, TRIX to the smoothed trend itself accelerating. In practice MACD turns earlier and more often, which is why the two are sometimes used together — an early signal that TRIX later confirms.
- Why does my TRIX barely move?
- Because it is working as designed. Triple smoothing at period 14 removes most of what a shorter oscillator responds to, and the resulting values are small in absolute terms — often four or five decimal places on a currency pair. The chart auto-scales so the shape is visible; the number itself is not meant to be read against a fixed level.
- What period should I use?
- 14 is MT5's default and the sensible starting point. Remember that the smoothing compounds, so raising the period slows the indicator much faster than the same change would on a single EMA — 25 is already a regime-level setting. Whatever you choose, re-validate it on your pair and timeframe rather than carrying a number across from another market.
- Can I build a TRIX EA without coding?
- Yes. The TRIX Zero Cross + EMA200 template crosses TRIX against a Constant of 0 for the trigger, uses an EMA(200) compared against price to decide which side is allowed, and trails the stop to the most recent confirmed fractal. The period, the applied price, the EMA length and the fractal lookback are all EA inputs.
- How should I validate settings before going live?
- Backtest on quality tick data, then run on a demo account before risking money. Because TRIX signals are rare, a backtest over a short window may contain only a handful of trades — that is far too few to conclude anything, so use a long period and check how many entries actually occurred before reading the profit figure. Hold back data the search never saw.